Davey XF171S Electric Single Stage Transfer Pump
Robust & compact, 1 or 2 stage centrifugal pumps with corrosion resistant componentry and driven by a TEFC motor. Designed for total head duties to 33m and flows to 225 lpm.
APPLICATIONS
Ideal for pumping clean, nonvolatile liquids without fibres or solids in such applications as:
• Irrigation
• Aquaculture
• Water transfer
• Washing systems
• Hydroponics
Power: 450W
Voltage: 220/250V
Inlet: 1″ Female
Outlet: 1″ Male
Max flow: 175LT/min
Max Pressure: 170kPa
Ideal for pumping slightly aggressive, non-volatile liquids without fibres or solids in applications such as:
• Sea water
• Aquaculture
• Mild acid solutions
• Washing systems
• Hydroponics
• Desalinated water
THERMOTECTION
Thermotection will automatically stop the pump should the water in the casing reach 85ºC. This condition may occur when a fully primed pump is operated without being allowed to discharge water (i.e. closed head operation).
Thermotection control will automatically restart the pump when the water temperature drops below 65ºC±5ºC.
•Manufactured from quality corrosion resistant materials.
•TEFC motor corrosion resistant and excludes dust and dirt.
•Motor and pump designed for frequent starts.
•Quick and easy installation.
•Low maintenance.
•Easy to service if required.
•Protected against pump damage from closed head operation.
FEATURES & BENEFITS FEATURES & BENEFITS
Davey manufactured TEFC IP55 motor is corrosion resistant and resists low pressure jets of water, dust and dirt for long service life in arduous conditions. Closed vane corrosion proof impellers with full length “D” drive for positive, robust impeller drive. Motor and pump are designed for frequent starts providing a long and reliable working life. Pump shafts (and casing on two stage models) are manufactured from quality corrosion resistant stainless steel for long service life when pumping less than perfect water. Every pump is performance and pressure tested in our factory to ensure quality and reliability. All models come fitted with a 2m power lead with 10 amp Australian three pin plug for ease of connection to power supply. High quality mechanical shaft seal for long life and reliability.
Easy to service design for shorter downtime if or when service is required. Permanently split capacitor design motor for reliable starting even in low voltage circumstances. Double contact C3-HTG sealed bearings for quieter running and longer life. In-built automatic-reset thermal overload protection embedded in the motor for quick response to motor overloading. Motor overloading can be the result of extreme ambient temperature, high or low voltage (beyond specification), pump blockage and / or pumping fluids heavier than fresh water (eg sea water). Plastic feet used on motor shell for long life in poorly drained installations.
INSTALLATION & PRIMING
• Installations with suction lift require a good quality foot valve to avoid loss of prime
• To prime, fill pump body and suction line through priming plug hole located above suction inlet and replace plug
