Davey D150S Single Channel Waste Pump
SKU: D150S
The D150s models are a high head, single channel, stormwater and sewage handling submersible sump pump
Capable of pumping soft solids in suspension up to 2150lpm
A choice of single or three phase motors. Installing with slide rail kits is recommended
“A” models include auto float switch
Operating Limits
Capacities to 750 LT/min
Max Total head 17.5
Max submergence 25m
Max operating temperature 40 c
maximum soft solids up to 80% of discharge size
Outlet size 3″ (M)
Electrical Data
Supply Voltage 220- 240 /50 Hz single phase
Cable Length 10 metres
Output ( watts ) 1500
Start (amps) 65
Run (amps) 13
Speed 2 pole , 2850rpm
Features and Benefits
Corrosion resistant 304 stainless steel shaft, motor shell and fasteners
* Long service life
*Attractive lasting appearance
Open impeller, single channel, centrifugal design
* Able to pump soft solids in suspension
* Less susceptible to blockage
Mechanical shaft seal in oil bath with hard faced silicon carbide/ceramic seal on pump side
*Added motor protection
*Long service life
*Protect against overloading
Sand slinger lip seal
*Added protection
*Long service life
Corrosive resistant 304 stainless steel motor shell, shaft, strainer and fasteners with high quality paint finish
* Long service life
* Attractive, lasting appearance
Automatic resetting thermal overload
* Protected against overloading
HO7RNF oil resistant leads, 10 metres long with 3 pin power plug
* Easy to connect to power supply
* Longer life in dirty water
Installation & Priming
- Use a rope to position and retrieve the pump. Do not lower or retrieve the pump using the power lead as this may damage the cable entry seals, causing water leaks and unsafe operation.
- Don’t use this product for recirculating or filtering swimming pools, spas, etc. While these pumps are built to high safety standards, they are not approved for installations where people will be in the water while they are operating.
- Don’t pump abrasive materials. Sand and grit in the water being pumped will accelerate wear, causing shortened pump life.
- Keep your pump clean, particularly in situations where lint, hair or fibrous materials may get bound around the pump shaft. Regular inspection and cleaning will extend pump life.
- Make room for the float switch to operate. Automatic models have a float switch to turn them on when the water level rises and turn them off again when it has been pumped down to the safe operating level of the pump. If the float switch is not free to rise and fall, correct pump operation may not be possible.
- Don’t run your pump dry. Non-automatic models must be switched off manually or by way of an external float/level switch when the water level is reduced to the top of the pump housing.
